Omron fh-1 series - Restoring Saved Settings

9 - 27
9 Saving/Loading Data
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
9-7 Backing up Sensor Control-
ler Setting Data [Configuration
9
9-7-3 Restoring Saved Settings
Saved settings for a sensor controller can be restored, or copied.
This section explains the procedures for loading a sensor controller project with the Configuration copy
function.
Important
• Do not manually edit a file in a sensor controller project. Doing so will cause an error and the
project will not be readable.
• Before loading a sensor controller’s project, it is recommended to back up the setting of the
Sensor Controller. If failure to load a sensor project occurs, the sensor controller does not
return to its previous state.
• When connecting an external storage device to the sensor controller, make sure that it is the
same drive name and same device as the sensor controller project was saved. If not, loading
the sensor controller project fails.
1 Connect the External Memory device to the Sensor Controller.
2 From the [Tool] menu, select [Configuration Copy].
3 [Confirm] dialog box is displayed.
After confirming, please click [Continue] button. [Configuration copy tool] starts.
4 Click [Load] tab.
9-7-3 Restoring Saved Settings