9 Saving/Loading Data
9 - 14
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
• You can change the Communicate Module after restarting. Restart it after loading, if you load
the system data that is changed the Communicate Module. For applying the details of param-
eters after restarting, you should re-load the system data.
Additionally, you can load only once because the bkd data write the backup data at once.
• Layout settings will be applied when [Switch layout] is executed.
Note that Layout change remains until [Switch layout] is executed when System data which
changes the layout setting is loaded.
• When the Scene data created via FZ series Sensor Controller, i.e. FZ5 series or FZ5-L
series, [Camera Image Input] is automatically converted to [Camera Image Input FH].
The automatically converted contents is the common items between [Camera Image Input]
and [Camera Image Input FH]. The other settings is set to the default settings of the con-
nected camera to the FH series Sensor Controller.
• When FZ series Sensor Controller loads data created by FH series Sensor Controller, the
data will not be automatically converted.
To Next Page
Loading...
