9 - 29
9 Saving/Loading Data
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
9-7 Backing up Sensor Control-
ler Setting Data [Configuration
9
9-7-3 Restoring Saved Settings
6 Select the sensor controller’s project from [Select a sensor controller’s project].
Select the Sensor Controller's project on the [Folder selecting] window with clicking [...] in
[Select a sensor controller's project].
The version and note of the Sensor Controller of selected the sensor controller's project is dis-
played in the information view.
Selected Version information and Note are displayed in the information display label.
7 Click [Execute] button.
Starts to load the setting data including the selected sensor controller project in Step 6.
The following screen is displayed.
If an error occurs during this process, refer to below.
Refer to 9-7-4 Troubleshooting on page 9-30.
Do not turn off the power, or disconnect the external memory device during the loading of the
sensor controller project. Doing so may cause damage to the external memory, or the sensor
controller project.
8 The following confirmation dialog box is displayed when the loading is finished.
Restarting the Sensor Controller is required to apply the loaded settings
To Next Page
Loading...
