9 - 31
9 Saving/Loading Data
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
9-7 Backing up Sensor Control-
ler Setting Data [Configuration
9
9-7-4 Troubleshooting
An error message occurred
because loading of the
Sensor Controller's project
failed.
"File writing failed."
Insufficient free memory in Sen-
sor Controller
Resave to the Sensor Controller after increas-
ing free memory space by deleting Scenes, or
Processing units, adjusting the measurement
region of Processing unit, or registered model
size.
External storage is not plugged
in.
Plug in the external storage.
Sensor Controller's project files
is corrupted.
• Power was possibly turned off during last
save operation.
• Insufficient memory can occur due to
increased memory requirement for current
Operation mode.
A Sensor Controller project
saved by FH series/FZ5-800/
1100/1200 series is loaded by
FZ5-L series/FZ5-600 series.
Save destination of Scene group can differ if the
created environment and loading environment
are different.
Set the save destination.
An error message occurred
because loading of the
Sensor Controller's project
failed.
"File destination does not
exist."
External storage is not plugged
in.
Plug in the external storage.
Drive name of external storage
differs from the Sensor Control-
ler project.
Set the save destination.
Change screen of the save
destination setting for
Scene grope is displayed.
A Sensor Controller project
saved by FH series/FZ5-800/
1100/1200 series is loaded by
FZ5-L series/FZ5-600 series.
Save destination of Scene grope can differ if the
created environment and loading environment
are different.
Set the save destination.
Model type is different from
saved Sensor Controller and
loading one.
Save destination of Scene grope can differ.
Reset the save destination.
Connected storage configuration
differs.
Phenomenon Cause Action
To Next Page
Loading...
