3 Basic Operations
3 - 40
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
5 Click the [Run] button.
Note that the Sensor Controller must be placed in a measurement capable state.
Precautions for Correct Use
Do not connect or disconnect the [Remote Operation Tool] during a measurement or the sys-
tem running.
6 Click [Browse].
A "Network reference" list will be displayed.
When you run the simulation software of the sensor controller on the remote operation side PC,
the simulation software information may be displayed in the Network reference list.
7 Select your target Sensor Controller from the list, click [Initialize].
8 Click [OK].
The Controller is initialized and restarted.
To Next Page
Loading...
