485
Conversion Instructions Section 3-12
Example The following diagram shows an example BCD-to-binary conversion.
In this example, N words of BCD data is converted to binary data.
If N = 3, the three words of BCD starting from D00010 will be converted to
binary data one word at a time when CIO 00000 turns ON. The resulting
binary data will be stored starting from D00100.
3-12-2 DOUBLE BCD TO DOUBLE BINARY: BINL(058)
Purpose Converts 8-digit BCD data to 8-digit hexadecimal (32-bit binary) data.
Ladder Symbol
Variations
Applicable Program Areas
Operand Specifications
×10
3
×10
2
×10
1
×10
0
×16
3
×16
2
×16
1
×16
0
R
BCD#0200
D00100
BCD
BIN
BCD#0100
BCD#0300
D00101
D00102
D00010
D00011
D00012
NEXT
BIN
,IR0+
FOR
&3
,IR1+
MOVR
D10
IR0
MOVR
D100
IR1
00000
00000
Decimal &200
Decimal &100
Decimal &300
(Hexadecimal #00C8)
(Hexadecimal #0064)
(Hexadecimal #012C)
BINL(058)
S
R
S: First source wor
R: First result word
Variations Executed Each Cycle for ON Condition BINL(058)
Executed Once for Upward Differentiation @BINL(058)
Executed Once for Downward Differentiation Not supported
Immediate Refreshing Specification Not supported
Block program areas Step program areas Subroutines Interrupt tasks
OK OK OK OK
Area S R
CIO Area CIO 0000 to CIO 6142
Work Area W000 to W510
Holding Bit Area H000 to H510
Auxiliary Bit Area A000 to A958 A448 to A958
Timer Area T0000 to T4094
Counter Area C0000 to C4094
DM Area D00000 to D32766
EM Area without bank E00000 to E32766
To Next Page
Loading...
Need help?
General
