Returning the Server to Operation
After replacing components inside of the server, perform the procedures in the following
sections.
Description Links
Install the server top cover. “Install the Server Top Cover” on page 161
Install the fan door assembly top cover. “Install the Fan Assembly Door” on page 163
Remove any antistatic measures. “Remove Antistatic Measures” on page 164
Reinstall the server chassis in the rack. “Reinstall the Server in the Rack” on page 164
Return the server to the normal rack position. “Return the Server to the Normal Rack
Position” on page 165
Reconnect power and data cables. “Reconnect Power and Data Cables” on page 167
Power on the server. “Power On the Server” on page 167
Related Information
■
“Preparing for Service” on page 47
Install the Server Top Cover
1.
Place the top cover on the chassis.
Set the cover down so that it hangs over the rear of the server by about 1 inch (25 mm) and the
side latches align with the cutouts in the chassis.
2.
Check both sides of the chassis to ensure that the top cover is fully down and
flush with the chassis.
If the cover is not fully down and flush with the chassis, slide the cover towards the rear of the
chassis to position the cover in the correct position.
Returning the Server to Operation 161
To Next Page
Loading...
Need help?
General