Disconnect Cables From the Server
Caution - When you power down the server using Oracle ILOM, the server enters standby
power mode. Power is still directed to the service processor remote management subsystem and
power supply fans. To completely power off the server, you must disconnect the power cords
from the power supplies.
Related Information
■
“Power Down the Server for Immediate Shutdown Using the Power Button” on page 52
■
“Power Down the Server for Immediate Shutdown Using the Oracle CLI” on page 52
■
“Power On the Server” on page 167
Disconnect Cables From the Server
Caution - The system supplies standby power to the circuit boards even when the system is
powered off.
1.
Depending on the components that you are servicing, either extend the server to
the maintenance position, or remove the server from the rack.
2.
Power down the server.
See “Powering Down the Server” on page 51.
3.
Disconnect the power cords from the rear of the server.
4.
Disconnect all data cables from the rear of the server.
5.
Detach and remove cables from the cable management device.
Related Information
■
“Rear Panel Components and Cable Connections” on page 15
■
“Powering Down the Server” on page 51
■
“Extend the Server to the Maintenance Position” on page 55
■
“Remove the Server From the Rack” on page 56
■
“Reconnect Power and Data Cables” on page 167
54 Oracle Exadata Storage Server X5-2 High Capacity Service Manual • January 2018
To Next Page
Loading...
Need help?
General