Oracle EXADATA X5-2 - Page 53

Power Down the Server for Immediate Shutdown Using the Oracle ILOM Web Interface
2.
From the CLI prompt, type the following command:
-> stop -f /System
The server powers down immediately.
3.
Disconnect the power and data cables from the server.
See “Disconnect Cables From the Server” on page 54.
Caution - When you power down the server using Oracle ILOM, the server enters standby
power mode. Power is still directed to the service processor remote management subsystem and
power supply fans. To completely power off the server, you must disconnect the power cords
from the power supplies.
Related Information
■
“Power Down the Server for Immediate Shutdown Using the Power Button” on page 52
■
“Power Down the Server for Immediate Shutdown Using the Oracle ILOM Web
Interface” on page 53
■
“Power On the Server” on page 167
Power Down the Server for Immediate Shutdown Using the
Oracle ILOM Web Interface
Caution - This procedure quickly forces the server main power off. You might corrupt your
system data during an immediate power-down, so use this procedure to power down the server
only after attempting the graceful power-down procedure.
1.
Log in to the Oracle ILOM web interface using an Administrator account.
The Oracle ILOM web interface System Information → Summary Information page appears.
2.
In the left pane, click Host Management → Power Control, and click Immediate
Power Off in the Select Action list.
3.
Click Save, and then click OK.
The server powers down immediately.
4.
Disconnect the power and data cables from the server.
See “Disconnect Cables From the Server” on page 54.
Preparing for Service 53