BIOS Advanced Menu Selections
Setup Options Options Defaults Description
control uses two wires to
send start/stop signals.
BIOS Advanced Menu Trusted Computing Options
The following table describes the BIOS Advanced Menu trusted computing options:
TABLE 25
BIOS Advanced Menu Trusted Computing Options
Setup Options Options Defaults Description
TPM Support Disabled/Enabled Disabled Enable or disable Trusted
Platform Module (TPM)
support. Only UEFI BIOS
implements this setup
option. If disabled, the OS
will not show TPM. Reset
of the platform is required.
TPM State Disabled/Enabled Disabled Displays whether TPM
Support is enabled.
Note - This option is
available only if TPM
Support is set to enabled.
Pending Operation None/Enable Take
Ownership/Disable Take
Ownership/TPM Clear
None Used to schedule an
operation for the security
device.
Note - Your computer will
reboot during restart in
order to change the state of
a security device.
Current Status
Information
If TPM Support is
disabled, Current Status
Information displays
SUPPORT Turned OFF.”
TPM Enabled Status Disabled/Enabled Disabled Use this option to provide
the current capability state
of the security device.
Note - This option is
available only if TPM
Support is set to enabled.
TPM Active Status Deactivated/Activated Deactivated Use this option to provide
the current capability state
of the security device.
BIOS Setup Utility Menu Options 213
To Next Page
Loading...
