Select Legacy BIOS or UEFI BIOS Boot Mode
2.
When prompted, press the F2 key to access the BIOS Setup Utility.
3.
To ensure that the factory defaults are set, do the following:
a.
Press the F9 key to automatically load the optimal factory default settings.
A message appears prompting you to continue this operation by selecting OK or to cancel
the operation by selecting Cancel.
b.
In the message, highlight OK, and then press Enter.
The BIOS Setup Utility screen appears with the cursor highlighting the first value on the
screen.
4.
Press the F10 key to save the changes and exit the BIOS Setup Utility.
Alternatively, you can save the changes and exit the BIOS Setup Utility by navigating to the
Exit Menu and selecting Save Changes and Reset.
Related Information
■
“Access BIOS Setup Utility Menus” on page 179
■
“BIOS Setup Utility Menus” on page 178
■
“BIOS Key Mappings” on page 179
Select Legacy BIOS or UEFI BIOS Boot Mode
The BIOS firmware supports both Legacy BIOS BOOT Mode and UEFI BIOS Boot Mode.
The default setting is Legacy BIOS Boot Mode. For more information about selecting the BIOS
boot mode, refer to “Using UEFI” on page 183.
1.
Access the BIOS Setup Utility menus.
See “Access BIOS Setup Utility Menus” on page 179.
2.
From the BIOS Main Menu screen, select Boot.
The Boot Menu screen appears.
3.
From the Boot Menu screen, use the up and down arrow keys to select UEFI/
Legacy BIOS Boot Mode, and then press Enter.
188 Oracle Exadata Storage Server X5-2 High Capacity Service Manual • January 2018
To Next Page
Loading...
Need help?
General