Remove the Internal USB Flash Drive
Caution - Ensure that all power is removed from the server before removing or installing a
flash drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following topics:
■
“Remove the Internal USB Flash Drive” on page 93
■
“Install the Internal USB Flash Drive” on page 94
Related Information
■
“USB Ports” on page 174
Remove the Internal USB Flash Drive
1.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the server power
supplies.
See “Powering Down the Server” on page 51.
b.
Extend the server into maintenance position.
See “Extend the Server to the Maintenance Position” on page 55.
c.
Attach an antistatic wrist strap to your wrist, and then to a metal area on the
chassis.
See “Electrostatic Discharge Safety” on page 48.
d.
Remove the server top cover.
See “Remove the Server Top Cover” on page 58.
Servicing Components That Require Server Power-Off 93
To Next Page
Loading...
Need help?
General