Assign Serial Port Output Using the Web Interface
Note - You can change the boot priority using the Boot Device Priority screen available in the
Boot menu of the BIOS Setup Utility.
1. NET 0
2. NET 1
3. NET 2
4. NET 3
Ethernet Port Device Naming
Note - Naming used by the interfaces might vary from that listed below depending on which
devices are installed in the system.
The device naming for the Ethernet interfaces is reported differently by different interfaces and
operating systems. The following table shows BIOS (physical) and operating system (logical)
naming conventions used for each interface. These naming conventions might vary depending
on conventions of your operating system and which devices are installed in the server.
Port BIOS Solaris Linux Windows (example default
names, see note below)
NET 0 3A00 ixgbe 0 eth 0 Ethernet
NET 1 3A01 ixgbe 1 eth 1 Ethernet 2
NET 2 8200 ixgbe 2 eth 2 Ethernet 3
NET 3 8201 ixgbe 3 eth 3 Ethernet 4
Rear Panel Pinhole Switches
This section shows the location of the rear panel pinhole switches.
Troubleshooting and Diagnostics 43
To Next Page
Loading...
