Lock the Robot 9-3
Lock the Knob-type Robot Lock (new version) 9-4
Lock the Thumbscrew-type Robot Lock (older version) 9-4
Restart the Library 9-5
Restarting the Library Following a Power Outage 9-5
Audit the Library 9-5
Monitor an Audit in Progress 9-6
Move the Library Rack 9-6
Enable the Locate Light 9-7
Troubleshoot the Library 9-7
Diagnose a Browser-Based User Interface Problem 9-7
Diagnose a Library Problem 9-8
Diagnose Why You Cannot Login to the Remote Interface 9-8
Use the Health Table to Diagnose the Issue 9-8
Check if a Fault is Closed in the Health Log 9-9
Locate and Remove a Cartridge Stuck in a Magazine Slot 9-10
Locate and Clear Obstructions, Such as Loose or Protruding Cartridges 9-10
Save the Health Log to a File 9-11
Run a Self-Test 9-11
Restore the Factory Default Configuration 9-12
SAS-2 and SAS-3 Configuration Issues 9-13
Get Parts and Technical Support 9-14
Check for Relevant Knowledge Articles 9-14
Get Firmware Updates 9-14
Create a Service Request 9-14
Run a Self-Test 9-15
10
Replace Components (CRUs & FRUs)
CRU Locations 10-2
Drive Tray Removal and Replacement 10-2
Remove the Drive Tray 10-3
Replace the Drive Tray 10-4
Remove New Drive Tray from Package 10-4
Replace the Drive Tray 10-4
Verify the Library Recognized the New Drive Tray 10-4
Install the Drive Slot Cover 10-5
Power Supply Removal and Replacement 10-5
Remove the Power Supply 10-6
Replace the Power Supply 10-6
Install a Power Supply Slot Cover 10-7
ix
To Next Page
Loading...
