Panasonic MINAS-A5NL Series - Page 3

No. SX-DSV02310
R2.0 Motor Business Division, Appliances Company, Panasonic Corporation
Revisions
Date Page Rev. Description Signed
Sep. 15, 2011 1.0 NEWLY ISSUED -
Oct. 20, 2011
7
1.1 ADDITION Note of matching settings with upper device added -
58
CORRECTION Type
Code Echo in example of reading of vendor name
was compatible  newly created
61
ADDITION Note “*2)” added in table of list Type Code
80
ADDITION Contents of In
Position added in description after stopping
internal command generation process
83
MODIFICATION/ADDITION Start-up conditions for profile
performance command arguments and
timing for reflecting parameters were
organized
Nov.18,2011 1 1.2 Added the description of “*”(Check the software version) -
7,25 Added the description of “[bit 2], [bit 3]”(Pr7.22)
52,53,56,60,68,73
,84
Added the description of “For details, refer to Sections 7-7-1.”
69,70,71 Added the description in Description(000h,001h,002h,011h,021h)
74 Added the description in Description(010h,101h)
75 Added the description of “RTEX communication”(befor reset commmand)
140 Changed the description of ”Pr7.32->Pr7.35”
140 Changed the description of “Disable->FF Disable”(Command_Data3)
140
Added the description of “When setup is ･･･”(Note:)
Mar.30,2012 All 1.3 Changed company name. -
5,7 Added the description of pulse regeneration.
35 Added the description of Response_Data1,2,3(Description)
38
Added the description of position deviations in other than electronic
gear(1/1).
131,132,133,135 Changed the description of Profile homing 2.
Apr.1,2013
All
2.0
Changed company name.
-
1
Software upgrade Ver8.01 -> Ver8.02
The table of changes is added.
( This mark is added to a description change part.)
5,7,46,50,51,101,
120,122,146,161
1) Block Diagram of 2 Degrees of Freedom Mode
64
2)"b-contact" setting of the input signal (HOME, POT, NOT, EXT1, EXT2,
EXT3) used as a home position reference trigger and a latch trigger
62,67,83,110
3)The falling edge (HOME, POT, NOT) used as a home position reference
trigger
Note: The page number (Page) is the current page number at the time of revision.
2.02.0