Parker Compax3 S150 V4 User Manual

Parker EME
Error
I11 T11 192-120101 N6 - March 2004 99
Note:
Utype error
Error code (hex):
0xFF15
Error:
Parity error
Error reaction:
None
Measure:
Note:
Utype error
Error code (hex):
0xFF16
Error:
Frame error
Error reaction:
None
Measure:
Note:
Utype error
Error code (hex):
0xFF20
Error:
Flash sector delete failed
Error reaction:
None
Measure:
Note:
Error while deleting flash
Error code (hex):
0xFF21
Error:
Program flash cell failed
Error reaction:
None
Measure:
Note:
Error while programming flash
Error code (hex):
0xFF22
Error:
Checksum error of prog. Flash area
Error reaction:
None
Measure:
Note:
Error for flash checksum
Error code (hex):
0xFF23
Error:
DOWN/UPLOAD activated
Error reaction:
None
Measure:
Note:
Download or upload is active
Error code (hex):
0xFF24
Error:
DOWN/UPLOAD not activated
Error reaction:
None
Measure:
Note:
Download or upload is inactive
Error code (hex):
0xFF30
Error:
EEPROM Delay Count Error
Error reaction:
None
Measure:
Note:
Internal error
Error code (hex):
0xFF40
Error:
Not enough memory for OSZI or AWL reserved
Error reaction:
None
Measure:
Note:
An attempt was made to reserve too much memory (IEC, osci)
Error code (hex):
0xFF42
Error:
No objects available
Error reaction:
None
Measure:
Load application data into device (objects)
Note:
Application data error; no valid objects present
LED red flashing
Error code (hex):
0xFF43
Error:
No IEC61131 program
0xFF15
0xFF16
0xFF20
0xFF21
0xFF22
0xFF23
0xFF24
0xFF30
0xFF40
0xFF42
0xFF43

Parker Compax3 S150 V4 Specifications

General

Output Current	150 A
Control Type	Digital
Series	Compax3
Model	S150 V4
Enclosure Rating	IP20
Communication Interfaces	CANopen, RS-232, RS-485
Feedback Options	Resolver
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Relative Humidity	5 to 95% non-condensing
Operating Temperature	0 to +45 °C (32 to 113 °F)