Pitney Bowes Connect+ 1000 - Setting the System Clock; Setting System Timeouts

Chapter 8
l
If you have a fast network connection and uploads are going quickly, you can raise the
threshold if you feel the warnings are appearing too frequently. This will allow the system
to create more files before the warning appears.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select System from the list on the left side of the screen.
3. Select Postal Information Upload.
4.
Select the Enable Postal Upload Warning check box.
l
A check mark indicates that the warning is enabled.
l
If the check box is empty the warning is disabled.
5. Select and drag the control button along the slide bar to adjust the threshold. Use the +
and - buttons for a more precise selection.
6. Select Done to save your changes.
Setting the System Clock
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select System from the list on the left side of the screen.
3. Select Clock.
4. Select Synchronize clock to synchronize the clock.
5.
To turn daylight saving time on or off select On or Off.
NOTE: Turn Daylight Saving Time on in the Spring and off in the Fall.
6. Select the appropriate time zone from the Time Zone list.
7. Select Done to return to the Home screen.
Setting System Timeouts
System timeouts can be set for your mailing system. You can set any of the system timeouts
from five minutes to four hours, in one minute increments.
166
SV62250 Rev. G