Connect+® Series Operator Guide
4. Select Billing Class in the Job Properties list box.
a. Select the class of postage you want to use to bill your customer.
b. Select OK.
5. Select Start to begin running mail.
Graphics and Permit-Only Printing
If you have a graphics and permit-only printing system, you have a fully-featured Connect+®
Series system with a deactivated meter, which prevents postage printing. Graphics and per-
mit-only systems can run non-postal jobs as well as utilize sealing and accounting features
with no meter charges.
NOTE: Although a Connect+® Series graphics and permit-only system cannot print post-
age, the United States Postal Service (USPS) still requires an electronic inspection of the
meter. Periodically, you will receive a "Postal Inspection Required" message on your sys-
tem. You can check your balance at Pitney Bowes to satisfy this requirement. Refer to Your
Postage Meter for more information about postal inspections.
Running Mail
With a graphics and permit-only system you can:
l
Print the correct date on a piece of mail that already has postage printed on it.
l
Print the received date and time on incoming mail for record keeping.
l
Print a graphic on the envelope.
l
Print a permit on a piece of mail.
l
Seal envelopes without printing postage.
l
Count how many pieces of mail you run.
l
Track the mail you run with the integrated accounting feature.
NOTE: If the default job on your system is a postal job, the Low Funds warning will appear
each time you open the Run Mail application. Change the default job to a job that does not
print postage (e.g. Permit or Graphic ad only) to prevent this message from appearing.
56
SV62250 Rev. G
To Next Page
Loading...
