Chapter 8
Zeroing the Scale
You may need to zero the scale if the scale will not display zero weight.
NOTE: Always make sure there is nothing on the scale when the system is powered up. At
power up, the system will automatically zero the scale.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select Attached scale.
4. Select Zero scale.
5. Select Done to return to the Home screen.
Resetting the Localization Value
When you replace your attached scale, you are required to reset the localization value for the
scale.
Refer to the installation instructions supplied with the scale for instructions on resetting the
localization value.
Setting the WEIGH-ON-THE-WAY® (W-O-W®) Weight Limit
You can set the WEIGH-ON-THE-WAY® (W-O-W®) weight limit to prevent the system from
printing postage on pieces of mail that exceed a set weight.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select WEIGH-ON-THE-WAY® (W-O-W®).
4. Select the lbs. field.
a. Use the numeric keypad to enter the weight in lbs.
b. Select the oz. field and enter the appropriate weight.
c. Select OK.
5. Select Done to return to the Home screen.
176
SV62250 Rev. G
To Next Page
Loading...
