Pitney Bowes Connect+ 1000 - Job Types; Weighing Methods

Connect+® Series Operator Guide
1.
Select the modified job.
NOTE: An asterisk appears next to job name when it has been edited or modified.
2. Select Reload job.The system reverts to the previously saved version of the job.
Job Types
When creating a new job, you can select from the following job types.
l
Select Seal only, no printing if you only want to seal the envelope and do NOT want to
apply postage.
l
Select Date correction when you need to print the correct date on a piece of mail that
already has postage printed on it.
l
Select Postage correction if you do not have the correct amount of postage on a piece of
mail.
l
Select Received date and time if you want to print the date or time on incoming mail for
record keeping.
l
Select Graphic ad only if you only want to print a graphic on the envelope.
l
Select Permit if you want to print a permit on a piece of mail.
l
Select Postal if you want to print postage on a piece of mail.
l
Select Count only if you want to count mail without printing postage.
l
Select Weigh-Rate-Count if you want to track the weight and rate of your mail pieces as
well as count mail without printing postage.
NOTE: The Count only and Weigh-Rate-Count job types are only available if your system
uses accounting.
Weighing Methods
When creating a postal job, you can select from the following weighing methods.
l
WEIGH-ON-THE-WAY® (W-O-W®) - This method processes mixed mail (mail of var-
ying sizes and weights, depending your system configuration) and determines the post-
age amount based on the weight and dimensions of each mail piece.
33
SV62250 Rev. G