Chapter 10
Possible Cause Solution
There is a obstruction in the moist-
ener pad assembly area.
l
Check that there is enough E-Z
Seal® sealing solution in the
envelope sealant bottle.
l
Remove or lift the moistener
pad assembly. Verify that there
is no interference with the pad,
that the pad is wet and that
there is E-Z Seal® solution in
the small reservoir.
l
Check the envelopes, and
ensure that the contents are
tamped to the upper right hand
corner.
Troubleshooting: Tape Feeding
Description: Tape stoppage is occurring.
Possible Cause Solution
l
Adhesive is left on the leading
edge of the new tap roll.
l
The leading edge of the tape is
rolled or folded under the tape
roller.
1. If necessary, remove the tape
roll.
2. Clear the tape stoppage.
3. Re-install the tape roll.
Description: System is not wetting gummed tape.
218
SV62250 Rev. G
To Next Page
Loading...
