Pitney Bowes Connect+ 1000 - Printer Maintenance; Printing a Test Sample

Connect+® Series Operator Guide
NOTE: Verify that the moistener pad assembly is perfectly level with the feed deck.
9. Close the feed cover.
10. Replace the envelope sealant bottle and close the supplies cover.
11. Select OK.
Connect+® 3000 Systems
1. Open the supplies cover and lift out the envelope sealant bottle.The bottle is located to
the left of the tape roll.
2. Lift the feed cover.
3.
Pull up on the top release lever.
4. Use the blue notch to pull on and open the moistener deck.
5. Use two fingers to remove the wick.
6. Clean the wick by holding it under running water.
7. Slide the wick back into place. Gently press down on the wick to ensure it is seated prop-
erly.
8. Push the moistener deck back into place.
9. Push down on the top release lever until it snaps into place.
10. Close the feed cover and select OK.
Printer Maintenance
The printer components, consisting of the ink cartridge and print head, require minimum
maintenance to ensure clean, clear printing on your mail.
Printing a Test Sample
You can print a test sample to check the print quality of the postage indicia without spending
any of your postage funds. If the sample has broken or missing lines, you may need to
replace the ink cartridge or print head.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware.
3. Select Printer.
188
SV62250 Rev. G