Pitney Bowes Connect+ 1000 - Hardware Settings; Changing the Scale Vibration Setting; Chapter 8

Connect+® Series Operator Guide
Hardware Settings
The Hardware settings allow you to view general information about your system and to
adjust hardware settings.
l
General - Select this option to view the model and serial number or to change the meter
name.
l
Attached scale - Select this option to zero the scale or to change the vibration setting.
l
Feeder - Select this option to adjust the waiting for envelope timeout.
l
WEIGH-ON-THE-WAY® (W-O-W®) - Select this option to select the weighing mode or
to set the weight limit.
Viewing your Model and Serial Number
The model and serial number are helpful to have on hand for rate changes, phone support,
and service.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select General. Your system name, model number, PSDPCN, PSDSerial number,
printer PCN and printer serial number display on the screen.
4. Select Done to return to the Home screen.
Changing the Scale Vibration Setting
You can turn the vibration filter on if your mailing system is in an environment subject to vibra-
tions, such as near air-conditioning vents or closing doors. If you select this, the scale will
require more time to settle before displaying a weight.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select Attached scale.
4. Select Adjust for motion to enable the vibration filter. Select Normal to disable the vibra-
tion filter.
5. Select Done to return to the Home screen.
175
SV62250 Rev. G