Connect+® Series Operator Guide
Setting the WEIGH-ON-THE-WAY® (W-O-W®) Mode
If you have a Connect+® 2000or Connect+® 3000mailing system, there are two WEIGH-ON-
THE-WAY® (W-O-W®) mode settings: normal and precision.
l
Normal is the default mode.
l
Precision mode allows you to obtain a more precise measurement of the weight and
dimensions of your mail pieces.
Follow the steps below to set the WEIGH-ON-THE-WAY® (W-O-W®) mode.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select WEIGH-ON-THE-WAY® (W-O-W®).
4. Select the appropriate mode.
5. Select Done to return to the Home screen.
Setting the Waiting for Envelope Timeout
Use this option to specify how much time to allow before the feeder stops after the last envel-
ope is processed. You can set system to run until Stop is selected on the Run Mail screen, or
you can set the system to stop running after a set amount of time, from 0 to 60 seconds.
This reduces the wear on your machine and acts as a safety measure if you leave the
machine unattended.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware from the list on the left side of the screen.
3. Select Feeder.
4. Select the appropriate length of time.
l
Select Stop machine immediately if you want the feeder to stop immediately after the
last envelope is processed.
l
Select Wait for envelopes for: if you want the feeder to continue running for a short
amount of time after the last envelope is processed. Select and drag the control button
to adjust the timeout. Use the + and - buttons for a more precise selection.
5. Select Done to return to the Home screen.
177
SV62250 Rev. G
To Next Page
Loading...
