Pitney Bowes Connect+ 1000 - Cleaning the Print Heads; Low Ink Warning

Chapter 9
4. Select either the Ink Cartridges or Print Head tab.
5. Select Print test sample.
l
To print the test sample on an envelope, place an envelope of the feed deck and
select Start.
l
To print the test sample on tape, select Tape.
6. Check the test sample.
l
If the solid lines of the test sample are unbroken, select Image is OK - Done.Skip to
step 7.
l If the test sample has missing or incomplete lines, select Not OK - Clean print head.
Once the cleaning operation completes, you will be prompted to print another test sam-
ple. If the pattern still has broken or missing lines, you may need to replace the ink car-
tridge or print head.
7. Select Done to return to the Home screen.
Cleaning the Print Heads
You can clean the print heads at any time to ensure optimal print quality.
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware.
3. Select Printer.
4. Select the Print head tab.
5. Select the Clean print head button. Print head cleaning takes approximately one minute.
A progress bar indicates the cleaning status.
6. Once the cleaning process is complete, you will be prompted to print a test sample.
Low Ink Warning
WARNING! Your system uses ink from the ink cartridges during normal maintenance
cycles. You must maintain adequate ink supply in all of the cartridges (black and color) to
keep the system in optimal working condition. Replace your ink cartridges promptly when
warned. Running the system with an empty ink cartridge may result in damage to printer
components that are not covered under your service agreement.
189
SV62250 Rev. G