Chapter 2
postage correction job settings.
NOTE: The weighing method is not displayed in the postage correction job. Sealing
mode is set to off.
4. Select Additional located to the right of the envelope or tape image. Type in the addi-
tional postage required and select OK.
5. If you are printing a tape, press the Tape button.
6. If you are printing on an envelope, turn the piece of mail around 180 degrees so that the
postal indicia is in the lower left corner.
a. Place the envelope on the feed deck with the flap facing down.
b. Press the Start button.
7. To save the job, select the Save As link at the top of the screen.
8. Enter the job name and select OK.
Printing the Received Date and Time
The Received date and time option allows you to print the current time and date, along with
the word “Received” on incoming mail. If you have already created a received date and time
job, open the job and begin running mail. If your system uses accounting, a piece count will
be retained for accounting reports.
Follow the steps below to create a received data and time job.
1. Select the Options button on the Run Mail screen.
2. Select Create new job... and then select Received date and time.
3. Select OK.
4. Select the appropriate print options:
l
Print "Received"
l
Print date
l
Print time
NOTE: When printing date and/or time, the sealer is set to off.
36
SV62250 Rev. G
To Next Page
Loading...
