Connect+® Series Operator Guide
l
Avoid touching moving parts or materials while the machine is in use. Keep hands, loose
clothing, jewelry and long hair away from all moving parts.
l
Do not remove covers or defeat safety interlock switches. Covers enclose hazardous
parts that should only be accessed by properly trained service personnel. Immediately
report to Pitney Bowes Service any damaged or non-functioning components that
renders the unit unsafe.
l
Place the unit in an accessible location to allow for proper venting of the equipment and
to facilitate servicing.
l
The power cord wall plug is the primary means of disconnecting the machine from the AC
supply.
l
Do not use an adapter plug on the line cord or wall outlet.
l
Do not remove the ground pin from the line cord.
l
Avoid using wall outlets that are controlled by wall switches, or shared with other equip-
ment.
l
Do not route the power cord over sharp edges or trapped between furniture.
l
Insure there is no strain on the power cord where it becomes jammed between the equip-
ment, walls or furniture.
l
Do not plug headphones into the Line Out jack (Lime Green).
l
Be certain the area in front of the wall receptacle into which the machine is plugged is
free from obstruction.
l
Before clearing a stoppage, be sure machine mechanisms come to a stop.
l
When clearing a stoppage, avoid using too much force to protect against minor personal
injury and damaging equipment.
l
To prevent overheating, do not cover the vent openings.
l
Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction. Contact your Pitney Bowes
Customer Service Representative for required service schedule.
l
Read all instructions before attempting to operate the equipment.
l
Use this equipment only for its intended purpose.
20
SV62250 Rev. G
To Next Page
Loading...
