Radwin WinLink 1000 - Figure 8-23 Telnetm

Configuration with Telnet Chapter 8
WinLink 1000 User Manual Release 1.9.40 8-27
Figure 8-23, below, shows the available Telnet commands using the help command.
Figure 8-23: Telnet Management window
set contact <new contact> Set the name of the site manager
set ethernet <port:MNG,LAN1,LAN2>
<mode:AUTO,10H,10F,100H,100F,DISABLE>
Set the mode and speed of each Ethernet port
reboot
Resets both the IDU and the ODU. The user is warned that the command
will reset the ODU. A new Telnet session to the ODU may be opened
after the reset is complete. (Watch the IDU LEDs.)
help Displays the available commands
admin@192.168.2.101-> Type "help" for help.
admin@192.168.2.101-> help
display inventory
display management
display link
display ethernet
display tdm
display ntp
display PM <interface:AIR,MNG,LAN1,LAN2,TDM1,TDM2,TDM3,TDM4>
<interval:current,day,month>
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:1-65535>
set readpw <writePasswd> <newPasswd>
set writepw <writePasswd> <newPasswd>
set trappw <writePasswd> <newPasswd>
set buzzer <mode:0=OFF,1=ON>
set tpc <power:Value between minimal TX power, and maximal TX power>
set bridge <mode:0=Bridging OFF,1=Bridging ON>
set name <new name>
set location <new location>
set contact <new contact>
set ethernet <port:MNG,LAN1,LAN2> <mode:AUTO,10H,10F,100H,100F,DISABLE>
reboot
help
Command "help" finished OK.
Table 8-2: Telnet Commands Summary (Continued)
Command Explanation