EasyManuals Logo

Radwin WinLink 1000 User Manual

Radwin WinLink 1000
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
Getting Started with the RADWIN Manager Chapter 4
WinLink 1000 User Manual Release 1.9.40 4-2
2. Choose Install RADWIN Manager and follow the on-screen instructions of the instal-
lation wizard to complete the setup of the RADWIN Manager application.
If the installation program fails to start, browse to your CD/DVD drive, chose the
setup.exe program and run it.
Getting Started with the RADWIN Manager
If your links are within easy reach, you can configure them using the procedure described
below. If however, your links are to be geographically scattered, it may be convenient to pre-
load each ODU with its network address prior to physical installation. The procedure is quite
straight forward, and set out in Chapter 19.
To start the RADWIN Manager:
1. Connect the managing computer to one of the two LAN ports as shown in Figure 4-
1 below:
Note
Each ODU requires a static IP address, since part of the link definition is the
IP address pair of both ODUs. Network Managers should ensure that these
addresses are outside of the automatic allocation ranges used by their
network DHCP server.
?

Table of Contents

Other manuals for Radwin WinLink 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radwin WinLink 1000 and is the answer not in the manual?

Radwin WinLink 1000 Specifications

General IconGeneral
BrandRadwin
ModelWinLink 1000
CategoryWireless Access Point
LanguageEnglish

Related product manuals