EasyManuals Logo

Radwin WinLink 1000 User Manual

Radwin WinLink 1000
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #304 background imageLoading...
Page #304 background image
Community String Appendix D
WinLink 1000 User Manual Release 1.9.40 D-2
on each of the IDUs and ODUs in the link. Both agents communicate with each other over the
air using a proprietary protocol.
To control and configure the device using the MIB, you should adhere to the following rules:
The connection for control and configuration is to the local site, over any SNMP/UDP/
IP network.
All Parameters should be consistent between both of the ODUs. Note that inconsis-
tency of air parameters can break the air connection. To correct air parameters incon-
sistency you must reconfigure each of the ODUs.
Common practice is to configure the remote site first and then to configure the local
site.
For some of the configuration parameters additional action must be taken before the
new value is loaded. Please refer to the operation in the parameters description.
Some of the MIB parameters values are product dependent. It is strongly recommend
using the RADWIN Manager Application for changing these values. Setting wrong val-
ues may cause indeterminate results.
Community String
To control a link, all SNMP requests should go to the local site IP address.
See Table 4-4 for default Community strings.
Private MIB Structure
The sections in the private RADWIN MIB and its location in the MIB tree are shown in
Figure D-1 below:
Note
Each ODU has a single MAC address and a single IP address.

Table of Contents

Other manuals for Radwin WinLink 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radwin WinLink 1000 and is the answer not in the manual?

Radwin WinLink 1000 Specifications

General IconGeneral
BrandRadwin
ModelWinLink 1000
CategoryWireless Access Point
LanguageEnglish

Related product manuals