Radwin WinLink 1000 User Manual

RFP: RADWIN 2000 Considerations Chapter 10
WinLink 1000 User Manual Release 1.9.40 10-9
• If you mix RADWIN 2000 and WinLink 1000 units in a collocated site, you must use
RFP B or E
• Selection of the RFP influences the capacity, latency and TDM quality
• RFP influences capacity and latency. Jitter buffer configuration can be used to set the
TDM quality (see Chapter 5, TDM Services selection)
• Using the Link Budget Calculator, you can see the affect of the RFP on the Ethernet
throughput.
RFP: RADWIN 2000 Considerations
• The performance of RADWIN 2000 radios that operate with RFPs B or E can be seen
in the Link Budget Calculator.
• For RADWIN 2000 C series: If the HSS Master works in asymmetric Tx/Rx ratio, then
all other collocated RADWIN 2000 units must operate in the same Tx/Rx ratio. In this
case the ratio will be fixed and not automatic-adaptive.
• Installation/Configuration considerations: If you are using RADWIN 2000 C master
and RADWIN 2000 clients, the Services and Rates dialog will look like this:
Figure 10-11: Services and Rates - RADWIN 2000 C master, RADWIN 2000 clients
• The circled areas should not be used. Using those areas, you may loose the collocated
link with the longest distance between sites. If you do move the slider into a circled
area, you will receive a popup warning:

Radwin WinLink 1000 Specifications

General

Brand	Radwin
Model	WinLink 1000
Category	Wireless Access Point
Language	English