Radwin WinLink 1000 User Manual

Default WinLink 1000 Settings Chapter 4
WinLink 1000 User Manual Release 1.9.40 4-11
The Link Installation and Configuration phases are both carried out with Wizards, which
“walk you through” the processes. The Wizards are visually quite similar and will be
described in detail below.
3. Site Configuration - described in Chapter 8.
Site specific configuration for each side of the link is available at any time - under a run-
ning link or under the restricted Installation mode.
Site Configuration consists of a set of panels, which may be invoked individually in any
order, as needed.
Default WinLink 1000 Settings
The default settings of the WinLink 1000 configuration parameters are listed in the second
column of Table 4-4 below. The third column shows the values we use in this manual for
illustrative purposes.
Note
An installed and configured link can be returned to installation mode for re-
installation and configuration from last settings or from factory settings.
• Reversion to installation mode requires a complete break in the link
service
• Configuration mode may vary the service throughput and quality, but
without a service break
Table 4-4: Default Settings
Parameter Default Value Illustrative Value
Factory default band Product dependent 5.780GHz
ODU IP Address 10.0.0.120 192.168.2.101 and 102
Subnet Mask 255.0.0.0 255.255.255.0
Trap destination 0.0.0.0 0.0.0.0
RADWIN Manager log-on
passwords
Observer admin
Operator admin
Installer wireless
Link ID Link EBG_20561334
Link Name Name TPSF_BTT
Site 1 Site A
Site 2 Site B
Location (per site) Location A B
Name (per site) Name Here There
Contact (per site) Person John Mary
Link Password wireless-bridge
Rate Adaptive

Radwin WinLink 1000 Specifications

General

Brand	Radwin
Model	WinLink 1000
Category	Wireless Access Point
Language	English