Radwin WinLink 1000

To Next Page

To Previous Page

FCC/IC 5.4/5.3 GHz Link Configuration Chapter 16

WinLink 1000 User Manual Release 1.9.40 16-6

Figure 16-6: FCC/IC 5.4/5.3 GHz operational

Main Page

Default Chapter3
- RADWIN Worldwide Offices3
- Regulatory Compliance4
  - Table of Contents8
  - Installation17
- Part 1: Basic Installation24
Chapter 1 Introduction25
- Welcome to Winlink 100025
- About Release 1.9.4025
- Key Applications25
- Odu Form Factors31
Chapter 2 Site Preparation45
- Planning the Link Site45
Chapter 3 Hardware Installation50
- Safety Practices50
Chapter 4 Getting Started with the RADWIN Manager65
- Installing the RADWIN Manager Application65
  - Minimum System Requirements65
  - Installing the Software65
- Link 100065
Chapter 5 Installing the Link77
- Overview77
- Installation79
- Step 1, Start the Wizard79
- Step 2, System Parameters79
Chapter 6 The RADWIN Manager: Main Window96
- One Manager for All RADWIN Radio Products96
- The Main Window of the RADWIN Manager96
- The RADWIN Manager Toolbar97
- Figure 6-1 Main Window97
- Main Menu Functionality98
- Figure 7-2 Configuration98
- Table98
- Radwin M98
- Elements of the RADWIN Manager Main Window99
- Table100
- Table 6-3 Status Bar Indicators102
Chapter 7 Configuring the Link104
- Overview104
- Table 7-1 Link Configuration105
- Configuration106
- Step 1, Start the Wizard106
- Step 2, System Parameters106
- Figure 7-1 Linkc106
- Step 3, Channel Settings107
- Figure 7-3 Channels108
- Figure 7-5 Channels109
- Figure 7-7 Choosing an110
- Step 4, Hub Site Synchronization Settings111
- Step 5, Services111
- Step 6, TDM Clock Configuration112
- Figure 7-9 Services and112
- Step 7, Configuration Summary and Exit113
- Figure 7-12 M114
Chapter 8 Site Configuration115
- Configuring the Site115
Chapter 9 Monitoring and Diagnostics142
- Retrieving Link Information (Get Diagnostics)142
- Link Compatibility143
- Figure 9-1 Get Diagnostics143
- Table 9-1 Get Diagnostics143
- TDM Loopbacks144
- Part 2: Site Synchronization163
Chapter 10 Hub Site Synchronization164
- What Is Hub Site Synchronization164
- Figure 10-1 I164
- Figure 10-2 C165
- Figure 10-3 C165
- Hardware Installation166
- Asymmetric Allocation173
  - RFP: Winlink 1000 Considerations174
Chapter 11 Using the RADWIN GSU179
- What Is It for179
- GSU Functionality179
- Typical GSU Scenarios179
- Onfiguration : Gps Sync Unit186
- Part 3: Advanced Installation192
Chapter 12 Monitored Hot Standby Installation Procedure193
- What Is a RADWIN Monitored Hot Standby193
- Onitored Hot Standby193
- Onnection Patch Panel195
Chapter 13 The RADWIN Ethernet Ring207
- Scope207
- What Is an Ethernet Ring207
Chapter 14 VLAN Functionality with Winlink 1000 VLAN Tagging - Overview217
- Qinq (Double Tagging) for Service Providers218
- VLAN Untagging218
- Port Functionality218
Chapter 15 Software Upgrade226
- What Is the Software Upgrade Utility226
- Upgrading an Installed Link226
- Figure 15-1 Softwareu227
- Figure 15-2 Add Site Options227
- Figure 15-3 a227
- Figure 15-4 S228
- Figure 15-5 Softwareu228
- Figure 15-6 S229
- Figure 15-7 S229
- Software Update for Gsus230
Chapter 16 FCC/IC DFS Installation Procedure231
- FCC/IC 5.4/5.3 Ghz Links: Background231
- FCC/IC 5.4/5.3 Ghz Link Activation231
- Figure 16-1 Activating an Figure 16-2 Airi232
- Figure 16-3 the Local233
- FCC/IC 5.4/5.3 Ghz Link Configuration234
- Figure 16-4 B234
- Figure 16-5 Channels235
- Part 4: Field Installation Topics237
- Table 17-1 Bill Ofm238
- Pole and Wall Installation238
Chapter 17 Pole and Wall Installation239
- Mounting an ODU on a Pole239
- Figure 17-4 M239
- Mounting an ODU on a Wall240
- Figure 17-5 Mounting on a240
- Mounting an External Antenna241
- Mounting a Connectorized ODU Horizontally241
- Figure 17-6 Mounted241
- Figure 17-7 I241
Chapter 18 Lightning Protection and Grounding Guidelines242
- Grounding for Antenna Cable242
- Grounding for Indoor/Outdoor Units243
Chapter 19 Preloading an ODU with an IP Address250
- Why this Is Needed250
- Required Equipment250
- Odu with250
Chapter 20 Changing the Factory Default Band256
- Why this Is Needed256
- Required Equipment256
- The Procedure256
- Figure 20-3 Changeb258
- Figure 20-4 a259
- Figure 20-5 Changeb259
- Changing Band for DFS260
- Special Products or Features: Entering a License Key260
- Figure 20-6 Mainw260
- Figure 20-7 Using Theo261
Chapter 21 Link Budget Calculator262
- Overview262
Chapter 22 Quick Install Mode275
- Why this Is Needed275
- Enabling Quick Install275
- Using Quick Install276
- Figure 22-1 Preferences276
- Figure 22-5 R277
- Part 5: Product Dependent Features279
Chapter 23 Reserved280
Chapter 24 Cascaded Links281
- About the RADWIN Cascaded Links281
- Installing Cascaded Links281
- Figure 24-1 Cascadedl281
- Figure 24-2 Configuring an Figure 25-1 Inactive Link State282
Chapter 25 BRS Installation Procedure283
- BRS Link Activation283
- BRS Link Configuration285
Chapter 26 Video Surveillance286
- About the RADWIN Video Surveillance Product286
- Installation287
- Part 6: Product Reference288
Appendix A Technical Specifications289
- Scope of These Specifications289
  - Odu289
  - Idu291
- Poe Device - Indoor, AC293
- Poe Device - Outdoor, DC293
- Gsu294
- Antenna Characteristics295
- Table A-1 Antennas295
Appendix B Wiring Specifications297
- ODU-IDU Cable297
- ODU/HSS Unit Connection Pinout297
  - User Port Connectors298
- DC Power Terminals301
Appendix C Small Form-Factor Pluggable Transceiver302
- IDU-C SFP Support302
Appendix D MIB Reference303
- Introduction303
  - About the MIB303
  - Terminology303
- Interface API303
  - Control Method303
  - Community String304
- Private MIB Structure304
- MIB Parameters305
- MIB Traps325
  - General325
  - Trap Parameters326
- RADWIN Manager Traps330
Appendix E External Alarms Specification331
- External Alarms Specification331
Appendix F RF Exposure336
Appendix G Regional Notice: French Canadian336
- Procédures de Sécurité336
- Installation Sur Pylône et Mur337
Appendix H Old Style IDU-E Details342

Radwin WinLink 1000 - Page 236

Table of Contents

Other manuals for Radwin WinLink 1000

Related product manuals