Installation Chapter 5
WinLink 1000 User Manual Release 1.9.40 5-4
Figure 5-2: Installation Wizard, System dialog box
To complete Installation Step 2:
1. Enter a Link ID. The Link ID must be identical for both ODUs in the link, oth-
erwise they will not communicate. The Link ID must include at least eight
alphanumeric characters. Up to 24 characters are allowed. You should use a Link ID
composed of both alphabetic and numeric characters.
2. Enter a Link Name for the link identification. The default name is “Link”. You should
change it.
3. Enter names for Site 1 and Site 2. The default names are both “Location”. You should
change them. Throughout this manual, we use A for Site 1 and B for Site 2.
4. Optionally enter a new Link Password.
Here is our completed System panel:
Note
If the Link Password is incorrect a link is established but configuration
cannot be performed and no services are available. A new link password
may be obtained from RADWIN Customer Support or use the alternative
password supplied with the product.
The link password is peculiar to the link itself and should not be confused
with the RADWIN Manager log on password.
To Next Page
Loading...
Need help?
General
