Network operation and remote control
R&S
®
LCX Series
148User Manual 1179.2260.02 ─ 02
To read the register, use the query commands STATus:OPERation:CONDition?
on page 209 or STATus:OPERation[:EVENt]? on page 209. The remote com-
mands for the operation status register are described in Chapter 11.14.1, "Status oper-
ation register", on page 208.
Table 10-3: Assignment of the bits used in the operation status register
Bit No. Meaning
0
CALibrating
The bit is set during the calibration phase (for service department only).
1
SETting
2
RANging
3
UPDate
4 0
5
TRIGger
This bit is set while the instrument is waiting for the trigger.
6 0
7 0
8
LIMit
9
INTegrating
10
LOGging
This bit is set as long as "Logging" is enabled
11
LOCKed
Instrument locked (RWLock)
12
INRush
13 0
14 0
15 This bit is always 0
10.2.4.3 Instrument-specific status questionable register
This status register contains information on questionable instrument states. Questiona-
ble states occur when the instrument is not operated in compliance with its specifica-
tions.
To read the register, use the commands STATus:QUEStionable:CONDition?
on page 210 and STATus:QUEStionable[:EVENt]? on page 211. The remote
commands for the status questionable register are described in Chapter 11.14.2, "Sta-
tus questionable register", on page 210.
Remote control interfaces and protocols
To Next Page
Loading...
