R&S RTC1000 - 13.3 Acquisition and Setup

Remote Commands Reference
R&S
®
RTC1000
171User Manual 1335.7352.02 ─ 02
Return values:
<ErrorCode> integer > 0 (in decimal format)
An error occurred.
(For details see the Service Manual supplied with the instru-
ment).
0
No errors occurred.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
13.3 Acquisition and Setup
● Starting and Stopping Acquisition......................................................................... 171
● Time Base.............................................................................................................172
● Acquisition.............................................................................................................174
● Vertical.................................................................................................................. 180
● Waveform Data..................................................................................................... 184
● Waveform Data Export to File...............................................................................191
● Logic Channel....................................................................................................... 192
● Probes...................................................................................................................197
13.3.1 Starting and Stopping Acquisition
RUN............................................................................................................................. 171
RUNContinous...............................................................................................................172
SINGle..........................................................................................................................172
RUNSingle.................................................................................................................... 172
STOP........................................................................................................................... 172
RUN
Starts the continuous acquisition.
Usage:
Event
Asynchronous command
Acquisition and Setup