Documenting Results
R&S
®
RTC1000
94User Manual 1335.7352.02 ─ 02
8 Documenting Results
The R&S RTC1000 can store various data to files for further usage, analysis and
reporting.
Waveform data and screenshots, which are intended for analysis outside the oscillo-
scope, are always saved to a USB flash drive. The USB flash drive is the external stor-
age location (FRONT USB). This location is only available if the USB flash drive is con-
nected.
Reference waveforms and instrument settings, which are intended for further use on
the instrument, are usually saved to the internal storage (/INT). You can also store
them to the external storage, or move them to the other location using the export and
import function.
The supported file system in all storage locations is FAT (FAT16/32). Prefer to use
USB flash drive up to 4 GB.
â–º To save and load data, press the SAVE/RECALL key in the General section.
8.1 Saving and Loading Instrument Settings
To repeat measurements or tests at different times or perform similar measurements
with different test data, you can save the used configuration settings. Furthermore, it
Saving and Loading Instrument Settings
To Next Page
Loading...
Need help?
General
