R&S RTC1000 - Pattern (Logic) Trigger

Remote Commands Reference
R&S
®
RTC1000
205User Manual 1335.7352.02 ─ 02
Parameters:
<Field> EVEN | ODD | ALL | LINE | ALINe
EVEN
Triggers only on even half frames.
ODD
Triggers only on odd half frames.
ALL
Triggers on all frames.
LINE
Triggers on the beginning of a specified line in any field.
The line number is set with TRIGger:A:TV:LINE
ALINe
Triggers on the beginning of all video signal lines.
*RST:
ALL
TRIGger:A:TV:LINE <Line>
Sets an exact line number if TRIGger:A:TV:FIELd is set to LINE.
Parameters:
<Line> Range: 1 to 525, 625, ..., 1080 depending on the TV stan-
dard
*RST: 1
13.4.5 Pattern (Logic) Trigger
TRIGger:A:PATTern:SOURce......................................................................................... 205
TRIGger:A:PATTern:FUNCtion........................................................................................206
TRIGger:A:PATTern:CONDition.......................................................................................206
TRIGger:A:PATTern:MODE............................................................................................ 206
TRIGger:A:PATTern:WIDTh[:WIDTh]............................................................................... 207
TRIGger:A:PATTern:WIDTh:DELTa.................................................................................207
TRIGger:A:PATTern:WIDTh:RANGe................................................................................207
TRIGger:A:PATTern:SOURce <SourceString>
Selects the state for each digital channel. The respective channel (CH1, CH2 or logic
channels 0...7) has to be activated before state selecting.
Parameters:
<SourceString> String containing 0, 1, or X for each channel.
1
High, the signal voltage is higher than the trigger level.
0
Low, the signal voltage is lower than the trigger level.
X
Don‘t care. The channel does not affect the trigger.
Trigger