R&S RTC1000 - Status Reporting

Remote Commands Reference
R&S
®
RTC1000
331User Manual 1335.7352.02 ─ 02
SYSTem:BEEPer:TRIG:STATe <TriggerBeep>
Enables or disables the beep if a trigger occurs.
Parameters:
<TriggerBeep> ON | OFF
SYSTem:BEEPer:CONTrol:STATe <ControlBeep>
Enables or diables a sound for general control events, e.g. reaching the rotary encoder
end or changing the measuring mode in the "Automeasure" menu.
Parameters:
<ControlBeep> ON | OFF
SYSTem:BEEPer:ERRor:STATe
<ErrorBeep>
Enables or disables the beep if an error occurs.
Parameters:
<ErrorBeep> ON | OFF
SYSTem:EDUCation:PRESet
Deletes the password of the education mode.
Usage:
Event
13.19 Status Reporting
13.19.1 STATus:OPERation Register
The commands of the STATus:OPERation subsystem control the status reporting
structures of the STATus:OPERation register:
See also:
●
Chapter C.1, "Structure of a SCPI Status Register", on page 348
●
STATus:OPERation Register
The following commands are available:
STATus:OPERation:CONDition?..................................................................................... 332
STATus:OPERation:ENABle........................................................................................... 332
STATus:OPERation:NTRansition.....................................................................................332
STATus:OPERation:PTRansition.....................................................................................332
STATus:OPERation[:EVENt]?......................................................................................... 332
Status Reporting