R&S RTC1000 - Cursor<M>:X1 Position; Cursor<M>:X2 Position; Cursor<M>:X3 Position; Cursor<M>:Y1 Position

Remote Commands Reference
R&S
®
RTC1000
219User Manual 1335.7352.02 ─ 02
Parameters:
<State> ON | OFF
*RST: OFF
CURSor<m>:X1Position <Xposition1>
Specifies the position of the first cursor on the time axis.
Parameters:
<Xposition1> Default unit: s
CURSor<m>:X2Position
<Xposition2>
Specifies the position of the second cursor on the time axis.
Parameters:
<Xposition2> Default unit: s
CURSor<m>:X3Position <Xposition3>
Specifies the position of the third cursor on the time axis for the Ratio X measurement.
Parameters:
<Position> Default unit: s
CURSor<m>:Y1Position <Yposition1>
Specifies the position of the first horizontal cursor on the y-axis.
Parameters:
<Yposition1> Default unit: V
CURSor<m>:Y2Position <Yposition2>
Specifies the position of the second horizontal cursor on the y-axis.
Parameters:
<Yposition2> *RST: V
CURSor<m>:Y3Position <Yposition3>
Specifies the position of the third horizontal cursor on the y-axis for Ratio Y measure-
ments.
Parameters:
<Position> Default unit: V
Measurements