R&S RTC1000 - Bus<B>:I2 C:frame<N>:Byte<O>:Complete

Remote Commands Reference
R&S
®
RTC1000
290User Manual 1335.7352.02 ─ 02
Return values:
<Acknowledge> INComplete | ACK | NACK | EITHer
INComplete
Acknowledge is incomplete
ACK
Acknowledge
NACK
No Acknowledge
EITHer
ACK or NACK
Usage: Query only
BUS<b>:I2C:FRAMe<n>:BYTE<o>:COMPlete?
Returns the information whethera data byte of a frame is received complete.
Suffix:
<b>
.
1, 2
Selects the bus.
<n> Selects the frame.
<o> Selects the byte number.
Return values:
<ByteComplete> ON | OFF
ON
Data byte was received completely.
OFF
Data byte was not received completely.
Usage: Query only
13.16.6 UART
● UART - Configuration............................................................................................290
● Trigger...................................................................................................................292
● Decode..................................................................................................................294
13.16.6.1 UART - Configuration
BUS<b>:UART:DATA:SOURce....................................................................................... 291
BUS<b>:UART:DATA:POLarity....................................................................................... 291
BUS<b>:UART:SSIZe.................................................................................................... 291
BUS<b>:UART:PARity................................................................................................... 291
BUS<b>:UART:SBIT...................................................................................................... 292
BUS<b>:UART:BAUDrate...............................................................................................292
BUS<b>:UART:BITime................................................................................................... 292
Protocol Analysis