R&S RTC1000 - 12.2 Remote Access Using a Web Browser

Network Connections and Remote Operation
R&S
®
RTC1000
157User Manual 1335.7352.02 ─ 02
12.2 Remote Access Using a Web Browser
The R&S RTC1000 firmware contains a web server. If a LAN connection is estab-
lished, you can access the instrument remotely using a web browser on the control
computer.
The browser access allows you to:
●
Check instrument data
●
Control the instrument remotely
●
Print screenshots
●
Send remote commands
●
Save waveform and instrument data
●
Check network settings
12.2.1 Accessing the Instrument Using a Web Browser
To access the R&S RTC1000, you need a LAN connection and the IP address of the
instrument.
1. Set up a LAN connection, see "Connecting the instrument to the LAN"
on page 154.
2. Obtain the IP address of the R&S RTC1000: SETUP > "DEVICE INFORMATION".
3. Open an Internet browser on the control computer.
4. Enter the IP address of the R&S RTC1000 in the address line:
http//:xxx.yyy.zzz.xxx.
The "Instrument Home" page opens.
12.2.2 Instrument Home
The "Instrument Home" page provides information on the instrument and the LAN con-
nection.
Remote Access Using a Web Browser