R&S RTC1000 - Edge Trigger

Remote Commands Reference
R&S
®
RTC1000
201User Manual 1335.7352.02 ─ 02
Parameters:
<OutputMode> OFF | TRIGger | MASK | GENerator
TRIGger:
Trigger event
MASK:
Mask violation
GENerator:
Generator signal
*RST: OFF
TRIGger:EXTern:COUPling
<ExternCoupling>
Sets the coupling for the external trigger input. The command is relevant if TRIGger:
A:SOURce is set to EXTernanalog.
Parameters:
<ExternCoupling> AC | DC
*RST: AC
TRIGger:OUT:POLarity <Polarity>
Sets the polarity of the trigger out pulse.
Parameters:
<Polarity> POSitive | NEGative
*RST: POS
TRIGger:OUT:PLENgth <PulseLength>
Sets the trigger output pulse length.
Parameters:
<PulseLength> *RST: 1E-6
Default unit: s
13.4.2 Edge Trigger
TRIGger:A:EDGE:SLOPe............................................................................................... 201
TRIGger:A:EDGE:COUPling........................................................................................... 202
TRIGger:A:EDGE:FILTer:LPASs..................................................................................... 202
TRIGger:A:EDGE:FILTer:NREJect...................................................................................202
TRIGger:A:EDGE:SLOPe <Slope>
Sets the slope for the edge trigger (A trigger).
Trigger