R&S RTC1000 - Bus<B>:Can:frame<N>:Byte<O>:Value

Remote Commands Reference
R&S
®
RTC1000
308User Manual 1335.7352.02 ─ 02
Return values:
<ByteStatus> OK | UNDF
OK
Data byte state is o.k.
UNDF
Data byte state is undefined.
Usage: Query only
BUS<b>:CAN:FRAMe<n>:BYTE<o>:VALue?
Returns the decimal value of the specified byte.
Suffix:
<b>
.
1, 2
Selects the bus.
<n> Selects the frame (1...n).
<o> Selects the byte number (1...n).
Return values:
<ByteValue> Decimal value
Usage: Query only
13.16.8 LIN
● LIN - Configuration................................................................................................308
● Trigger...................................................................................................................310
● Decode..................................................................................................................312
13.16.8.1 LIN - Configuration
BUS<b>:LIN:DATA:SOURce...........................................................................................308
BUS<b>:LIN:POLarity.....................................................................................................309
BUS<b>:LIN:STANdard.................................................................................................. 309
BUS<b>:LIN:BITRate..................................................................................................... 309
BUS<b>:LIN:DATA:SOURce <Source>
Sets the input channel to which the data line is connected.
Suffix:
<b>
.
1, 2
Selects the bus.
Parameters:
<Source> CH1 | CH2 | D0 .... D7
*RST: CH1
Protocol Analysis