R&S RTC1000 - Digital Voltmeter

Remote Commands Reference
R&S
®
RTC1000
256User Manual 1335.7352.02 ─ 02
Parameters:
<Function> ON | OFF
ON
Pin state is set to high (H).
OFF
Pin state is set to low (L).
*RST: OFF
Example:
PGEN:MAN:STAT2 ON
Pin state of s2 is set to high (H).
13.12 Digital Voltmeter
DVM<m>:TYPE............................................................................................................. 256
DVM<m>:SOURce.........................................................................................................257
DVM:ENABle.................................................................................................................257
DVM<m>:RESult[:ACTual]?............................................................................................ 258
DVM<m>:RESult[:ACTual]:STATus?................................................................................258
DVM<m>:RESult:RESet................................................................................................. 258
DVM:POSition............................................................................................................... 259
DVM<m>:TYPE <MeasurementType>
Selects the measurement type of the digital voltmeter function.
Suffix:
<m>
.
1..2
Selects the channel resp. the secondary measurement type.
Digital Voltmeter