R&S RTC1000 - Acquire:hresolution

Remote Commands Reference
R&S
®
RTC1000
180User Manual 1335.7352.02 ─ 02
ACQuire:HRESolution <HighRes>
Enables the high resolution mode.
Parameters:
<HighRes> AUTO | OFF
*RST: OFF
13.3.4 Vertical
CHANnel<m>:STATe..................................................................................................... 180
CHANnel<m>:COUPling.................................................................................................180
CHANnel<m>:SCALe..................................................................................................... 181
CHANnel<m>:RANGe.................................................................................................... 181
CHANnel<m>:POSition...................................................................................................181
CHANnel<m>:OFFSet.................................................................................................... 182
CHANnel<m>:BANDwidth...............................................................................................182
CHANnel<m>:POLarity...................................................................................................182
CHANnel<m>:OVERload................................................................................................ 182
CHANnel<m>:SKEW......................................................................................................183
CHANnel<m>:THReshold............................................................................................... 183
CHANnel<m>:THReshold:FINDlevel................................................................................ 183
CHANnel<m>:THReshold:HYSTeresis............................................................................. 183
CHANnel<m>:LABel.......................................................................................................184
CHANnel<m>:LABel:STATe............................................................................................184
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Suffix:
<m>
.
Selects the input channel (1, 2).
Parameters:
<State> ON | OFF
CHANnel<m>:COUPling <Coupling>
Selects the connection of the indicated channel signal.
Suffix:
<m>
.
Selects the input channel (1, 2).
Acquisition and Setup