R&S RTC1000 User Manual

Remote Commands Reference
R&S
®
RTC1000
309User Manual 1335.7352.02 ─ 02
BUS<b>:LIN:POLarity <Polarity>
Sets the polarity of the LIN.
Suffix:
<b>
.
1, 2
Selects the bus.
Parameters:
<Polarity> POSitive | NEGative
*RST: POS
BUS<b>:LIN:STANdard
<Standard>
Selects the version of the LIN standard that is used in the DUT. The setting mainly
defines the checksum version used during decoding. The most common version is LIN
2.x. For mixed networks, or if the standard is unknown, set the LIN standard to AUTO.
Suffix:
<b>
.
1, 2
Selects the bus.
Parameters:
<Standard> V1X | V2X | J2602 | AUTO
V1X
LIN Standard V1.x
V2X
LIN Standard V2.x
J2602
LIN Standard J206 (sets also BitRate to 10.417 KBit/s)
AUTO
Any standard
*RST: V1X
BUS<b>:LIN:BITRate <BitRate>
Sets the user defined bit rate for the CAN Decoder.
Suffix:
<b>
.
1, 2
Selects the bus.
Parameters:
<BitRate> Range: 1.00E+02 to 1.0081E+06
*RST: 9.6E+03
Default unit: Bit/s
Protocol Analysis

R&S RTC1000 Specifications

General

Brand	R&S
Model	RTC1000
Category	Test Equipment
Language	English