R&S RTC1000 - Page 353

Status Reporting System
R&S
®
RTC1000
353User Manual 1335.7352.02 ─ 02
Bit No. Meaning
6 User Request
This bit is set when the instrument is switched over to manual control.
7 Power On (supply voltage on)
This bit is set on switching on the instrument.
C.3.3 STATus:OPERation Register
In the CONDition part, this register contains information on which actions the instru-
ment is executing. In the EVENt part, it contains information on which actions the
instrument has executed since the last reading.
It can be read using the commands STATus:OPERation:CONDition? or
STATus:OPERation[:EVENt]?, see also Chapter 13.19.1, "STATus:OPERation
Register", on page 331.
Table C-3: Bits in the STATus:OPERation register
Bit No. Meaning
0
ALIGnment
This bit is set as long as the instrument is performing a self-alignment.
1
SELFtest
This bit is set while a selftest is running.
2
AUToset
This bit is set while the instrument is performing an auto setup.
3
WTRIgger
This bit is set while the instrument is waiting for the trigger.
4 to 14 Not used
15 This bit is always 0.
C.3.4 STATus:QUEStionable Register
This register contains information about indefinite states which may occur if the unit is
operated without meeting the specifications. It can be read using the commands
STATus:QUEStionable:CONDition? and STATus:QUEStionable[:EVENt]?
The remote commands for the STATus:QUEStionable register are described in Chap-
ter 13.19.2, "STATus:QUEStionable Registers", on page 333.
Contents of the Status Registers