REXROTH EcoDrive Cs - 9 Identifying the Components; Marking the Components; Type Plates; Type Plates at the Drive Controller

Rexroth EcoDrive Cs Drives Identifying the Components 9-1
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
9 Identifying the Components
9.1 Marking the Components
Each drive component is marked by a type designation.
A type plate is attached to all units including the motor.
A label (cable marker) is wrapped round the ready-made cable. The type
designation and length are indicated on this label. (The designation for the
cable itself - without connector - is printed on the cable sheath.)
The marking of accessories packed in bags is either printed on the bag or
indicated on an accompanying note.
9.2 Type Plates
Type Plates at the Drive Controller
typenschilder_anordnung.fh7
9
8
3
2
1
5
4
3
2
1
0 0
S3
7
6
5
4
9
8
7
6
ADDRESS
NODE
Rexroth
ECODRIVE
Cs
S1
H1
S2
LINE ERROR
X21
X20
TX
RX
S20
2
1
ON
X6
X1
X2
X3
2
1
1: type plate 1
2: type plate 2
Fig. 9-1: Type plate arrangement at the drive controller
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com