REXROTH EcoDrive Cs - DKC02.3-018 (750 W) Drive Controller with SERCOS Interface

Rexroth EcoDrive Cs Drives Technical Data (Drive Controllers) 4-3
DOK-ECODR3-DKC**.3-CS*-PR02-EN-P
DKC02.3-018 (750 W) Drive Controller with SERCOS interface
maszblatt_70.fh7
170
50
50
5172
10
70
10
5.2
182 160 11
5.2
2.5
X21
S20
X20
TX
RX
TRANSMITTER
POWER
1 2
OFF OFF
ON
OFF
ON
OFF
ON
ON
LOW
HIGH
LISTED 7Z45
A15
SN123456-F0001
123456-F0001
K40/02
Voltage
Phase
F.L.C
Freq.
Power
INPUT OUTPUT
200-230V 37V
3 3
1.1A 1.5A
50/60Hz 0-333.3Hz
750W
123456 Made in Japan Rexroth Indramat GmbH DKC02.3-001-3-MGP-01VRS
E164620
QR
R
Design notice
Do not touch terminals within 10 minutes after disconnect the power. Risk of electric shock.
High Temperature
Hazardous Voltage
Do not touch heatsink when power is ON. Risk of burn.
Read the manual and follow the safety instructions before use. Where residual-current-operated protective device(RCD) is used for protection in case of direct or indirect contact,only RCD of Type B is allowed on the supply side of this Electronic Equipment(EE). Never fail to connect Protective Earth(PE) terminal. 65/75í Wire Only. Use Copper Conductors Only. Refer to Manual for Wiring and Wire Size. Refer to Manual for Over Load Protection.
DANGER
X21
X20
X4
X5
X6
TX
RX
S20
ON
1
2
L1L2
L3
L1C
L2C
DL1
DL2
RB1
RB3
RB2
U
V
W
9
8
7
6
5
4
3
2
1
9
8
7
6
5
4
3
2
1
ADDRESS
NODE
0 0
Rexroth
ECODRIVE
Cs
S1
H1
S2
S3
LINE ERROR
X4
X5_3 X5_2 X5_1
INPUTíF200V-240V
X3 X2 X1
X6
Fig. 4-3: DKC02.3-018 (750 W) drive controller with SERCOS interface
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com